Axminster ujk 106843 매뉴얼 - 페이지 9

{카테고리_이름} Axminster ujk 106843에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster ujk 106843 20 페이지. Universal dovetail jig

Fig 09

4) The cutter size will generally match the board to be

slotted into the routed groove (eg 10mm board = 10mm

cutter). If a wider cut is required then comb or board

adjustments can be made & multiple cuts made to

achieve a wider groove slot. The cutter depth is optional

but for the best aesthetic & strength results set the

cutter depth to approx ⅔ the thickness of the material,

see fig 10.

Fig 10

5) Attach the magnetic extraction at the right hand end

of the support bar, see fig 11 or on a larger width board

attach the right hand side stop to the right hand end of

the jig to support the work, see fig 12-13-14.

Fig 11-12-13-14

Side Stop

GROOVE / HOUSING JOINTS

6) Start the cut at the right hand side of the jig moving

the router from right to left, see fig 15-16. in a slow steady

continuous motion DO NOT LIFT THE ROUTER AT ANY

TIME DURING A CUT- NB if working in very hard wood a

half depth cut may be required.

Fig 15-16

Trouble shooting -

• Groove deeper one end than the other - see fig 17

comb not sat flat on the board, see fig 18.

• Joint too tight - remove more material by slightly

adjusting comb position.

• Joint too loose - cutter too large.

• Joint not square on board - pencil line not marked

square, comb slot set gauge not used.

Fig 17-18

Magnetic

extraction