Axminster AHBGDL Hobby Series 사용자 설명서 - 페이지 13

{카테고리_이름} Axminster AHBGDL Hobby Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster AHBGDL Hobby Series 16 페이지. Wide stone grinder

Ensure that the grinder is disconnected from the mains supply.

Undo the nuts and bolts that secure the outer shell of the wheel guard to the

inner shell. Remove the outer shell and place it and the nuts, bolts and washers

carefully aside. (See fig 6)

WARNING!!

Be very careful that the stone cover does not 'spring' out of its location lip

on the inner cover, it can spring out with some force. (See fig 7)

Fig 6

Loosen the nut holding the

flange and the soft washer that is clamping the grindstone in place. (See figs 8 & 9) Then,

very carefully remove the grindstone from the shaft, take care that no damage or distortion

is done to the bush (if one is fitted). (See fig 10) Now is a good time to clean out the interior

of the wheel guard, removing any loose or compacted material that may have accumulated.

Carefully inspect the new grinding wheel before it is fitted, check that there are no cracks,

and there is no damage to either the front face or the edges. If required, fit the bush to the

grindstone. Carefully mount the grindstone onto the shaft, reposition the soft washer and

the wheel flange, replace the holding nut and tighten carefully. Do Not Overtighten. Refit

the outside shell of the wheel guard and secure with its nuts and bolts. Refit the tool rest,

positioning as in "Setting up the grinder". Fasten securely.

Fig 8

grinding wheel to the shaft. Carefully remove the nut, the plate

Nut

Changing a Grinding Wheel

Plate flange

Fig 7

Fig 9