Axminster MD150Q 사용자 설명서 - 페이지 16

{카테고리_이름} Axminster MD150Q에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster MD150Q 20 페이지. 150/200mm wetstone grinder
Axminster MD150Q에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Changing the dry grinding wheel...

A X M I N S T E R

W H I T E

Ensure that the grinder is disconnected from the mains supply.

Undo the nuts and bolts that secure the outer shell of the wheel guard to the inner

shell. Remove the outer shell and place it and the nuts, bolts and washers

carefully aside. (See fig 10)

Be very careful that the stone cover does not 'spring' out of its location lip

on the inner cover, it can spring out with some force. (See fig 11)

Loosen the nut holding the grinding wheel to the shaft. Carefully remove the nut, the plate

flange and the soft washer that is clamping the grindstone in place. (see figs 12 &13). Then,

very carefully remove the grindstone from the shaft, take care that no damage or distortion is

done to the bush (if one is fitted)(See fig 14).

Now is a good time to clean out the interior of the wheel guard, removing any loose or

compacted material that may have accumulated. Carefully inspect the new grinding wheel

before it is fitted, check that there are no cracks, and there is no damage to either the front

face or the edges. If required, fit the bush to the grindstone. Carefully mount the grindstone

onto the shaft, reposition the soft washer and the wheel flange, replace the holding nut and

tighten carefully.

Do Not Overtighten. Refit the outside shell of the wheel guard and secure with its nuts and

bolts. Refit the tool rest, positioning as in "Setting up the grinder". Fasten securely.

Continues on next page....

WARNING!!

Fig 10

Fig 11