Axminster Craft 105842 원본 사용 설명서 - 페이지 9

{카테고리_이름} Axminster Craft 105842에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster Craft 105842 17 페이지. Wide stone

CONNECT THE GRINDER TO THE

MAINS SUPPLY.

ALWAYS WEAR EAR DEFENDERS

AND SAFETY GOGGLES.

DISCONNECT THE GRINDER

FROM THE MAINS SUPPLY.

Step 1-2

Using a spanner remove the three nuts and washers from

the stone guard cover and place to one side.

Carry out final checks e.g. check the gap between the tool

rest and the stone is correct, check the stone is not badly

deformed (rounded edges, grooved face, etc; unless you

have specifically shaped the stone to these profiles), check

the eye shield is correctly positioned. Have a cooling pot to

hand if you need it. Start the machine, wait until it reaches

full speed. Check it runs smoothly, no knocking or scraping

noises for example. If all ok, switch off the grinder and wait

until it comes to a complete stop. Disconnect the machine

from the mains supply.

Changing the Grinding Stone

Remove side cover and place safely to one side.

Grasp the stone using a cloth, use a 24mm spanner to

loosen the nut, remember undo the nut in the direction of

the stone's rotation as indicated by the arrow on the guard

cover.

Setting Up the Grinder

Continues Over...

Step 3

Step 4