Axminster Craft 105110 원본 사용 설명서 - 페이지 5

{카테고리_이름} Axminster Craft 105110에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster Craft 105110 17 페이지. 300mm

페이지 인쇄

WARNING! THE SANDING DISC CANNOT BE DECLUTCHED FROM THE BELT

AND VICE VERSA, BOTH FUNCTIONS ARE ACTIVE WHEN THE MACHINE IS

RUNNING. REMEMBER THIS, AND DO NOT LEAVE LOOSE OBJECTS OF ANY

DESCRIPTION, ON THE MACHINE IF IT IS GOING TO BE USED.

Once the sander is mounted, carry out any

setting operations, (mitre, tilt...), and remove

all tools used in the setting operations (if

any) and place safely out of the way. If you

are working long lengths of material arrange

for extra support beyond the boundary of the

machine, and check you have sufficient room

to manoeuvre the material through all the

operations you will wish to carry out.

It is good practice to leave the machine

unplugged until work is about to commence,

also make sure to unplug the machine when it

is not in use. Always disconnect by pulling on

the plug body and not the cable.

After fitting a new sanding disc, it is good

practice to lightly sand across the left side

of the disc with a reasonable sized (20mm

x 50mm) piece of timber to make sure the

sanding disc is correctly 'seated' on the disc.

The sanding action will press the sanding disc

firmly back against the disc itself.

It is not good practice to wear gloves whilst

sanding as one tends to lose the 'feel' of the

workpiece/sander contact, but obviously

this removes the safety barrier between your

fingers and the sanding surface. Remain

focused and exercise caution whilst sanding.

DO NOT sand very small pieces of work with

bare hands; try to construct some form of

holder.

Specific to Sanding Machines

MAKE SURE you are comfortable before you

start work, balanced, not reaching etc.

If the work you are carrying out is liable to

generate excessive grit or dust or chips, wear

the appropriate safety clothing, goggles,

masks etc., If the work operation appears to

be excessively noisy, wear ear-defenders. If

you wear your hair in a long style, wearing a

cap, safety helmet, hairnet, even a sweatband,

will minimise the possibility of your hair being

caught up in the rotating parts of the machine,

likewise, consideration should be given to the

removal of rings and wristwatches, if these are

liable to be a 'snag' hazard.

DO NOT work with cutting/abrasive tools of

any description if you are tired, your attention

is wandering or you are being subjected to

distraction. A deep graze, a lost fingertip or

worse, is not worth it!

DO NOT use the machine within the designated

safety areas of flammable liquid stores or in

areas where there may be volatile gases. There

are very expensive, very specialised machines

for working in these areas, THIS IS NOT ONE

OF THEM.

CHECK that sanding surfaces are still

sufficiently abrasive to carry out the work you

intend. Sanding belt cleaning sticks are an

efficient method of prolonging the life of the

belts and discs, and will also maintain their

operating performance.

Continues Over...