AccuMed ABP801B 사용 설명서 - 페이지 12
{카테고리_이름} AccuMed ABP801B에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuMed ABP801B 15 페이지. Wrist blood pressure monitor
페이지 인쇄
TROUBLESHOOTING
If you have trouble in using the unit please check the following points first.
ERROR DISPLAY
Nothing is displayed when
you
push
the
button or
battery icon
flashes.
Can't normally increase
pressure
Inflate pressure is too high
Shaking while measuring
Battery icon on
The systolic pressure value
or diastolic pressure value
too high
The systolic pressure value
or diastolic pressure value
too low
ACCOMPANYING DOCUMENTS
A.Instructions for use
1.MODEL ABP801 needs special precautions regarding EMC and needs to be installed and
put into service according to the EMC information provided in the ACCOMPANYING
DOCUMENTS;
2.Portable and mobile RF communications equipment can affect MODEL ABP801.
B. Technical description
1. Warning that the use of accessories, transducers, and cables other than those specified
with the exception of transducers and cables sold by the manufacturer of the MODEL ABP801
as replacement parts for internal components, may result in increased EMISSIONS or
decreased IMMUNITY of the MODEL ABP801.
2. Warning that the MODEL ABP801 should not be used adjacent to or stacked with other
POSSIBLE CAUSE
No batteries installed
POWER
Batteries are dead
The batteries are installed
correctly
Check your wrist cuff for any
air leakage
Hand or body shaking while
measuring
Batteries have low power
The wrist cuff was held lower
than your heart
The
wrist
attached properly
You moved your body or
spoke while measuring
The wrist cuff was held higher
than your heart
You moved your body or
spoke while measuring
Insert batteries
Replace new batteries
Insert battery in the
correct polarities
Replace wrist cuff with
new one
Re-measure or send
back to dealer to
re-calibrate pressure
Keeping static and
correct gesture and
measure again
Replace batteries and
measure again
Keep
position,
and measure again
cuff
was
not
10
HOW TO CORRECT
the
correct
remain
still,