Axminster Trade 101701 원본 사용 설명서 - 페이지 11

{카테고리_이름} Axminster Trade 101701에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster Trade 101701 18 페이지.

Contour Sanding

Referring to Figure 19:

Contour sanding is done from the extension table

mounted on the motor where the sanding belt

wraps around the drive drum (D). To set up the

sander for contour sanding:

1. Loosen the two lock knobs (C) that secure the

drum guard & dust port (E).

2. Swing the end guard (E) back, bringing the

drive drum (D) into view.

3. Tighten the lock knobs (C).

4. Mount the extension table (A) to the sander by

inserting the post (B) into the bracket (F).

5. Set the table to the desired height, then secure

into position by tightening the lock knob (G).

Important: When the extension table (B) is not in

use, the drum guard & dust port (E) should always

be in the closed position so the drive drum (D) is

not in view.

Figure 19