Axminster Trade 501210 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Axminster Trade 501210에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axminster Trade 501210 17 페이지. 300mm disc sanders

Step 6 Check the pointer is set to ZERO on the tables scale

and adjust until correct (see fig 6).

Fig 06

WARNING! KEEP TOOLS AND

EQUIPMENT OUT OF THE REACH

OF YOUNG CHILDREN!

CLEAR ALL TOOLS AWAY FROM

SANDING AREA!

WARNING! WEAR A DUST MASK!

CONNECT THE SANDER TO THE

MAINS AND SWITCH ON.

Don't press too heavily against the sanding surface, all this

will do is slow the sander down. Remember, sanders work

by removing small particles of material quickly and heavy

pressure works adversely to the cutting process, further, it

will accelerate the rate of 'clogging' of the abrasive surfaces,

rendering the machine less efficient.

Pointer

Scale

WARNING! WEAR EYE

AND EAR PROTECTION!

Securing the Sander

It is recommended to secure the sander to a work bench or

stand using the four pre-drilled holes (d) in the chassis, (see

fig 07).

Operating Instructions

Sanding Configurations

Disc Sanding

Bevel Sanding

Setup/Adjustments

Fig 07

Fig 08

Fig 09