ABB TZIDC-210 사용 설명서 - 페이지 12

{카테고리_이름} ABB TZIDC-210에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB TZIDC-210 20 페이지. Electro-pneumatic positioner for profibus pa with flameproof enclosure

페이지 인쇄

3.1.2 Operating conditions at the installation site

WARNING

Ambient temperature:

Relative humidity:

Explosion protection:

Mounting orientation:

3.1.3 Mounting the positioner to linear actuators

A special attachment kit is available for mounting the positioner to a linear actuator

according to DIN/IEC 534 (lateral mounting to NAMUR) comprising the following parts:

3.9

3.8

3.7

Fig. 4

Mounting kit for linear actuators

Tools required:

Before installing check to ensure that the specifications in terms of safety

and control applicable to the TZIDC-210 positioner will not be exceeded at

the installation site of the actuator or final control element.

-40 °C ... +85 °C (-25 °C ... + 85 °C when using

proximity switches of type SJ2-S1N (NO))

95 % (mean annual value), condensation permissible.

Observe the specifications for protection class IP65/

NEMA 4X and the technical data in this manual.

Observe the technical data, and the specifications in the

certificates (see the relevant sections of this manual).

any orientation allowed

3.4

3.5

3.1

3.2

Wrench 10 mm /13 mm

Allen key 4 mm

Electro-pneumatic positioner TZIDC-210

3.0

2.1

2.2

2.3

2.0

• Lever (1.0) with

follower pin,

for 10 ... 35 mm or

for 20 ...100 mm

actuator travel

• Follower guide (2.0)

with two screws (2.1),

spring washers (2.2),

1.0

and clamp plates (2.3)

• Angle

with two screws (3.1),

and two plain washers

(3.2)

• Screw (3.4) and plain

washer

mounting to cast iron

yoke

• Two

U-bolts

each with two plain

washers

two

nuts

mounting to columnar

yoke

bracket

(3.0)

(3.5)

for

(3.7),

(3.8),

and

(3.9)

for

42/18-81 EN