ABB UniSec 운영 및 유지보수 매뉴얼 - 페이지 6

{카테고리_이름} ABB UniSec에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB UniSec 16 페이지.

U N I S E C D I G I TA L M A N U A L E D I F U N Z I O N A M E N TO E M A N U T E N Z I O N E

—

2. General information about UniSec Digital

The UniSec Digital monitoring system can be

configured with the following components:

• Concentrator MDC4-M

• Wireless temperature sensors

• Environmental sensor (optional)

• Gas pressure sensor (optional)

Each sensor is connected via cable or in the wireless

mode (in the case of temperature sensors) to the

concentrator, which collects all the data measured

and transmits them to the user via LHMI module or

mobile APP.

Typically, 3 wireless sensors are installed in the main

circuit of the digital units (cable connection

monitoring), but up to 9 can be installed if

monitoring relating to circuit-breakers and busbars

is required.

Temperature sensor

pressure

The sensors installed in the switchgear enable the

following operating parameters to be monitored:

• Temperature of the main circuit (the monitoring

points depend on how the switchgear has been

configured)

• Temperature and humidity levels in the cable

compartment

• ressure of gas in GSec/HySec apparatuses

NOTE

The sensors in the monitoring system do

not need to be calibrated

Ambient T/Humidity

Local HMI

MDC4 -M Data concentrator