Axon Fleet 3 사용자 설명서 - 페이지 13
{카테고리_이름} Axon Fleet 3에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axon Fleet 3 19 페이지. Camera system
Axon Fleet 3 Camera System
The swivel-ball joint has detents that click in every 22.5 degrees of horizontal rotation (pan)
to hold the camera in that position.
For ALPR usages, Axon recommends the following positioning
In most situations, including typical roadway patrol, aim the camera directly forward.
•
The ALPR lens will cover 3 lanes (the lane directly in-front and the immediate
adjacent lanes on either side of the vehicle).
When patrolling parking lots (with either perpendicular or diagonal parking), the user
•
can pan the camera to one of the off-center detents to better capture plate
information. Axon recommends either the 22.5 or 45 degree detents.
When parked roadside, panning the camera to the first off-center detent (22.5
•
degrees) will cover an additional lane of traffic (the lane immediately in front + 2
lanes adjacent to the same side).
Axon Signal
Axon Signal technology is included with the Fleet 3 system. However, your agency's Axon
Evidence administrator must configure the Axon Signal capability for it to work. When it is
configured, Axon Signal technology can automatically move your Axon Fleet and body
cameras from BUFFERING to EVENT mode.
When Axon Signal is triggered, such as by a light bar activation, the Fleet Hub alerts the
ethernet connected Axon Fleet 3 cameras. Additionally, when using Axon Body-Worn
Cameras (BWC) an Axon Signal Vehicle device, added during installation, alerts nearby Axon
BWCs using Axon Signal technology. These alerts cause your Axon cameras transition from
BUFFERING to EVENT mode. When an Axon camera starts recording, you will hear 2 tones or
beeps.
The Axon Signal Vehicle device, used to activate Axon BWCs, has a range of approximately 30
feet (9.1 meters).
Axon Signal technology can only send a signal to tell the camera to start recording. Axon
Signal technology does not end recording. For example, if a light bar is turned off, the
camera will continue to record until the user stops the recording.
The Axon Signal technology cannot power an Axon system on. If an Axon BWC is powered
off, the camera will not record even if an Axon Signal device sends a trigger signal.
Axon Enterprise, Inc.
User Manual
:
Page 13 of 19