Alphard DB-315 D2 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Alphard DB-315 D2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alphard DB-315 D2 20 페이지.
페이지 인쇄S E L E C T I O N O F T H E S P E A K E R C A B L E D I A M E T E R
Use the table below to select the desired diameter based on the length and the power consumption.
4 . R E Q U I R E D D E S I G N P A R A M E T E R S
Ш
В
Parameters/Model
The recommended amount of liters
Port area, cm²
Port length, cm.
Hz setting
5 . H O W T O U S E
The correct choice of the amplifier, its settings and design prolong the lifetime of your subwoofer. You should select an
amplifier with a nominal power below the nominal power of the subwoofer. Proper coordination of the head unit (HU) with the
amplifier will provide a clean, undistorted signal fed to the subwoofer, which prevents overheating and voice coil damage. Like
any other speaker the subwoofer has moving and stationary parts. We strongly recommend that the moving parts of the
subwoofer should be warmed up at the beginning of operation. Be extra careful when warming up the parts. Warm up the
subwoofer using musical material for 40 hours on medium power. If, during operation at maximum volume you feel strange
smell, you should make the volume of the subwoofer low and cool the device down at a low volume.
Recommended settings of the amplifier and HU: Volume of HU should not exceed 80%. The amplifier sensitivity is 50%,
subsonic filter frequency (Subsonic) is 5 Hz below the port settings. For example, if you configure the port at 30 Hz, Subsonic is
should be 25 Hz. The low pass filter LPF (the filter that cuts all frequencies above those set for the filter) 63-80 Hz, bassboost to 0.
25 000
20 000
15 000
10 000
8000
6000
4000
2000
1000
500
250
100
0-1 1-2 2-3 3-4 4-5 5-6 6-7
Bass reflex box
Д
DB-310
7-8
Cable length (m)
W*H*L = body volume
DB-312
40
55
100
200
25
70
37
35
7
Size
A.W.G mm²
5
16,8
8
8,37
5,26
10
14
2,08
DB-315
DB-318
100
160
300
450
65
70
32
30
EN