Axonn AXC550 설치 지침

{카테고리_이름} Axonn AXC550에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Axonn AXC550 2 페이지. Rf transceiver

Axonn Corporation

AXC550

Transceiver

Users Manual

RF Transceiver Installation Instructions

The AXC550 Transceiver is a member of our Spread Spectrum RF family of products.

This transceiver should only be installed by qualified service personnel.

The transceiver detects level, low battery or other data signals from the external

binary inputs and broadcasts that data to the system's host receiver.

MOUNTING LOCATION

The AXC550 Transceiver is a module as defined by the FCC and therefore must be

mounted to another host device in order to function.

NOTICE TO CUSTOMER

Any Axonn customer incorporating the AXC550 transceiver module into its own

product must have an external notice affixed to its product. This notice must be

placed in a conspicuous location and can use wording such as: "Contains FCC ID:

L2VAXC550" or "Contains Transceiver Module FCC ID: L2VAXC550". Any similar

wording that expresses the same meaning may be used.

INSTALLATION INSTRUCTIONS

1. Supply the transceiver with DC power by inserting two 3.6 Volt batteries into the

battery holder on the customers host application circuit board.

2. The unit will come pre-programmed with Transceiver ID and Property Code.

However, the customer does have the option of field programming the unit.

3. When installing the AXC550 you should avoid areas near screens, metal window

frames, circuit breaker boxes, air conditioners and heaters if a suitable location for the

unit may be found elsewhere.

CAUTION:

This device is required to comply with FCC RF exposure requirements for mobile

transmitting devices. The FCC requires that the antenna(s) used for this transmitter

must be installed to provide a separation of at least 20 cm (8 inches) from all persons

and must not be co-located or operating in conjunction with any other antenna or

transmitter.

TESTING THE TRANSCEIVER

Following system installation, system testing is mandatory. This should be performed by

locating the AXC550 in its final location and powering up the unit. On initial power-up,

the AXC550 will send out RF messages every 4 seconds or more depending on

programming. This will establish communications with the Host receiver and the

information collected will then be used to judge system performance.