Cinelex SKYBRIDGE 빠른 시작
{카테고리_이름} Cinelex SKYBRIDGE에 대한 빠른 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Cinelex SKYBRIDGE 2 페이지.
페이지 인쇄Cinelex SKYBRIDGE
Quick Start
1.
Plug in the USB Type B end ('square') of the USB cable into the bottom of the SKYBridge unit.
Connect the USB-A ('flat') End to a power source – e.g. a standard USB port or a USB AC Adaptor
2.
Wait for the device to boot-up, the device will be ready when the STATUS Led is solid.
3.
To connect to the WIFI of the SKYBRIDGE, the SSID will be SKYBRIDGE-XXXX
(where the X's represent any normal character 0-9, A-Z).
4.
The Password is: cinelex1
5.
Once connected, press the SYNC button on the SKYBRIDGE to begin pairing with the DMX
lights you wish to control, you will also need to press the sync button on the lights, this will
cause the STATUS light to begin to blink.
6.
On a web browser visit 10.0.0.1, this will bring up the control page for the SKYBRIDGE Device.
7.
You can now control the first eight DMX channels, and Save and Load a preset to the sliders.
8.
The SKYBridge Device also accepts ARTNET - to set this up:
9.
Close the Webpage.
10. Go into an application that is capable of sending ARTNET packets.
11. Setup an output to the IP Address 10.0.0.1
12. If the application is setup correctly the ARTNET light will be blinking as it receives packets.
13. The DMX values will now be sent via radio to your lights.
v1.1 May 2019