Alphatech BlueGate A 사용자 설명서 - 페이지 11
{카테고리_이름} Alphatech BlueGate A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alphatech BlueGate A 17 페이지. Gsm gateway
페이지 인쇄
0 0 n n n n Password nnnn to programming mode access
1 1 n n n n Memory x for permitted fix number (1 to 4 digits)
1 2 n n n n
1 3 n n n n
1 4 n n n n
1 5 n n n n
1 6 n n n n
1 7 n n n n
1 8 n n n n
1 9 n n n n
2 1 n
Reaction of GSM GATE at disconnection of GSM module
n=0 during disconnection is busy tone on the line
n=1 during disconnection is interrupted loop current
2 2 n
Acknowledge character setting
n=0 - #
n=1 - *
2 3 n
Type of dial tone n
n=0 – dial tone according table of tones
n=1 – dial tone of public lines operator
n=2 - quiet
Turning on combination for dialling „+„ to mobile phone
2 4 n
n=0 – combination turn off
n=1 – sending „+„ to mobile after „00„ dialling
Signalization to the call – short tone each minute
2 5 n
n=0 – tone is turn off
n=1 – tone is turn on
2 6 n
Restriction of call duration
n=0 – without restriction
n=1 – call duration restricted at 10 minutes
2 7 n
PIN
n=0 – start without PIN
n=1 – start with PIN
2 8 n
Type of acceptable dial of telephone number
n=0 – tone and pulse dial is acceptable
n=1 – pulse dial is acceptable only
n=2 – tone dial is acceptable only
2 9
Indication of signal power. Power is indicated by frequency of short tones.
Max. frequency is 5/ sec.
3 1 n n
Ringing after inicialization nn decimal of sec. (00 to 99 it is 9,9 sec)
(„00„ not ringing during inicialization)
3 2 n n
Waiting for last number nn sec. (01 to 15)
(after finishing of dial by acknowledge character is sending immediately)
3 3 n n
Waiting nn sec. for dial after pick up (00 to 99 it is 9.9 sec)
(„00„ waiting is not limited)
3 4 n n
Reaction of BLUE GATE on finishing of dial from GSM module
nn=00 – busy tone
nn=01-19 disconnecting of loop current on set time
Table of programming
- -
10
0 0 0 0
0
0
0
0
0
0
0 0
0 6
0 0
0 0