Alphatech BlueGate A 사용자 설명서 - 페이지 5
{카테고리_이름} Alphatech BlueGate A에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alphatech BlueGate A 17 페이지. Gsm gateway
페이지 인쇄When you inserted SIM card as same as all cables are
connected (do not forget that Blue gate is connected on
external line not on extension) connect device to main 230V.
The LED of „power supply„ is light up . After a few seconds will
start flashing a red diod on the board with TC 35 module – log
into GSM network. Till 15 seconds starts flashing LED
„communication to GSM„
„operation AB„ not lights. Then device is ready to work.When
pick up connected analogue phone or call to Blue Gate from
PBX the LED of analogue line lights up („operation AB„). In the
phone is hearing dial tone of Blue Gate.
The most often problems during Blue Gate compact
installation:
All LED is not lighting.Problem in power supply. Check
connection to main 230V as same as connection of
adapter to Blue Gate.
The LED „communication to GSM„ is flashing. After
calling to Blue gate is not light up LED „operation AB„ in
analogue phone is busy tone. The SIM card requires
PIN, which is not preprogrammed or is preprogrammed
wrongly.
The LED „communication to GSM„ is flash shortly one
for 2 sec. After calling to Blue Gate you are hearing
busy tone. Blue Gate is not log into GSM network – bad
signal.
The LED „communication to GSM„ is flashing. After
calling to Blue gate is not light up LED „operation AB„ in
analogue phone is quiet. It interrupted conduction of
analogue line or so much big resistance in current loop
(for example:( longer cabel between PBX and Blue
Gate).
in cca 2 sec. period and LED
- - 4