Alphatron PEDESTRAL 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Alphatron PEDESTRAL에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alphatron PEDESTRAL 7 페이지.

3B EXTENDED SET-UPS (optional):

The Pedestal can be enlarged using the optional extension 150 and 300. For sitting work the

above described set-up will do. For standing, depending on the length of the user the extensions

are used.

Placing Extensions:

- Remove the three Locking Screws (22) that hold the

column in the Base Piece (21) using the supplied hexagon

key.

- Take off the Column with spider and lay it aside.

- Mount the extension(s) you need using the same

hexagon key. Fix them firmly but do not use too much

force for there is a chance of damaging the tool or the

screws.

- Take the Column and mount it on top of the

extension(s).

- Lower the Tensioning Pens (13)

- Loosen the Spider Clamp Ring (9) with the two locking

screws and let it slide down until the spider legs fit the

Tensioning Pens. Then fasten the Spider Clamp Ring

again with both screws.

- Tension the Spider using the Tension Pens (counter

clockwise).

3C LOW SET-UPS:

- Remove the three locking screws (5) that hold the Bowl Unit on the inside column (6) using the

supplied hexagon key.

- Take off the Bowl Unit and lay it aside.

- Remove the three locking screws (22) that hold the column in the base piece (21) using the

supplied hexagon key.

- Take off the Column with spider and lay it aside.

- Mount, if necessary the extension you need using the same hexagon key. Fix them firmly but do

not use too much force for there is a chance of damaging the tool or the screws.

- Take the Bowl unit and mount it on top of the extension(s) or directly to the Base Piece (21) of

the Dolly.

- A special low set up is possible using only the Bowl unit, placing it on its rubber feet on the

ground or a table.