ABB ACS150 series 설치 지침 - 페이지 2

{카테고리_이름} ABB ACS150 series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACS150 series 2 페이지. Mirco drives
ABB ACS150 series에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 설치 지침 (4 페이지), 빠른 설치 및 시작 매뉴얼 (2 페이지), 빠른 설치 및 시작 매뉴얼 (2 페이지), 설치 지침 (4 페이지)

Grounding

clamps

6. Install the clamp for the control cable, or if cables are run in

conduits, replace all clamps with suitable glands (not included).

Run cables through the clamps and tighten. Strip cable ends.

Fasten the grounding conductor (PE) of the input power cable

and the twisted shield of motor cable under the grounding

clamps. Connect the connectors to appropriate terminals. See

Electrical installation in the drive manual.

10. Fasten the hood to drive with two M3×12 screws.

11. Fasten the hood to wall with one M4 screw (not included).

ABB Oy AC Drives P.O. Box 184 FIN-00381 HELSINKI FINLAND Tel. +358 10 22 11, Fax: +358 10 22 22681, Internet: http://www.abb.com

Clamp

7. Install the gland box cover.

8. Fasten the cover with two M4×12 screws.

12. Drive with MUL1-R3 option installed.

9. Install the hood. First position the front edge carefully, then

press the hood downwards until it snaps on.