ABB ACS350 Series 설치 지침

{카테고리_이름} ABB ACS350 Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ABB ACS350 Series 4 페이지. Nema 1 series enclosure kit for abb acs150; abb acs350
ABB ACS350 Series에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 사용자 설명서 (14 페이지), 설치 지침 (4 페이지), 설치 지침 (4 페이지)

페이지 인쇄

ACS310, ACS320, ACS350 and ACS355

MUL1-R4 Installation Instructions

WARNING! Before installing MUL1-R4

option, read the safety instructions and

mechanical and electrical installation

instructions in the drive User's Manual.

Follow the instructions when installing,

operating and servicing the drive. If

ignored, physical injury or death may

follow, or damage may occur to the

drive, motor or driven equipment.

Note: You cannot lead the Safe torque off (STO) cable

through the gland plate in the ACS355.

3. If control cables or fieldbus option modules will be installed,

remove the detachable lid (3) from the gland box cover.

M4×8

1. Fasten the gland box frame to drive with two M4×16 screws

and one M4x8 screw. Note: The M4×8 screw is already

installed in the drive.

4. With any fieldbus option module except FRSA-00, install the

option grounding plate to the gland box frame. See Mechanical

installation in the drive manual.

2. Fasten the gland box frame to wall with four M4 screws (not

included).

5. Install the clamp (5a) for the control cable, or if cables are run

in conduits, replace all clamps with suitable glands (not

included). Run cables through the clamps and tighten. Strip

cable ends. Fasten the grounding conductor (PE) of the input

power cable and the twisted shield of motor cable under the

grounding clamps (5b). Connect the conductors to appropriate

terminals. See Electrical installation in the drive manual.

3AUA0000025916 Rev. C / 2010-01-25

(

)