Cini QSO 300 기술 지침 - 페이지 5

{카테고리_이름} Cini QSO 300에 대한 기술 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cini QSO 300 6 페이지. Immersing heater with electronic thermostat

VERTICAL INSTALLATION ON THE DRYER

5.7 If you are sure whether you installed the heater and thermostat in accordance with previous

instructions, you can connect the thermostat to the power network, in the socket with grounding.

Cable cross-section in the installation and the type of connection must be appropriate.

5.8 Immediately after the connection to the power network, the thermostat indicators will turn on and

off in an easily discernible sequence, and the indicator marked with a snowflake

temperature indicator

If after 10 seconds after turning on the heater to an electrical installation all indicators flash in the

same regime, there has been an error while installing the thermostat on the heating element. Turn off

the thermostat from the electrical wiring, loosen the screw on the back of the thermostat, remove the

thermostat from the heater and carefully repeat the thermostat installation procedure.

6. USE

If you are sure that you have installed all the elements in accordance with these instructions, you may

plug the cable into the socket with protective grounding. Installation cable cross-section and the type

of connection must be appropriate.

After the self-test, the indicator

in accordance with the procedure described in 4.2.4.2 above.

WARNING



The heater is designated exclusively for direct installation on radiators or towel dryers –heater

power must not exceed 70% of the power in the heating body that incorporates the heater – it is

prohibited to connect the electric heater to power supply if is not completely submerged in

water – it is prohibited to install the heater in heating bodies that are filled with aggressive

fluids.

and the heater operation indicator (3) will remain turned on.

will illuminate. You may choose the wanted temperature range

HORIZONTAL INSTALLATION ON THE RADIATOR

, the