ARC Audio X2 2500.1 소유자 매뉴얼 - 페이지 7

{카테고리_이름} ARC Audio X2 2500.1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARC Audio X2 2500.1 11 페이지. Class d monoblock amplifier

페이지 인쇄

Fuses

The X2 Series Monoblock amplifiers included on-board ATC/

ATO fuses on the left side of the end-panel. These fuses exist

to protect the internal circuitry of the amplifier from damage

and are not a replacement for a proper fuse at the battery in

your vehicle. Under no conditions should you increase the

value of the fuses used in this location.

If the fuses blow immediately upon insertion, contact your

authorized ARC Audio dealer or the Technical Support

department at ARC Audio for assistance.

X2 650.1

2 x 30 Amp

X2 1100.1

3 x 30 Amp

X2 2500.1

6 x 30 Amp

Auto Sense Turn-On Detection

All three X2 Series Monoblock amplifiers feature two Auto-

Sense Turn-On modes. In DC Detect mode, these amplifiers

monitor the Channel 1 RCA input for the presence of a DC

offset voltage (common with Bridge Tied Load (BTL) source

units and amplifiers). When this DC voltage is present, the

amps will turn themselves on.

When set to Signal Detect, these amplifiers will monitors the

Channel 1 RCA input for the presence of an audio signal.

When an audio signal is present, the amp will turn itself on.

These amplifiers turn off automatically 10 seconds after

the DC Detect or Signal Detect circuit no longer sees an

appropriate signal.

When using either Auto-Detect mode, only the Channel 1

input is monitored.

The Turn On input on the power terminal block is NOT

used when Auto Detect is turned on.

Accessing Controls and Mounting Provisions

All X2 Series Monoblock amplifiers feature a removable

shroud that conceals the amplifier controls. The X2 650.1

features X2 Level 1 cosmetics with the X2 1100.1 and X2

2500.1 feature Level 2 X2 Series cosmetics. The Level 2

shroud features an elegant new silver brushed-aluminum

extruded aluminum design. An acrylic plastic badge in the

center of the amp illuminates in blue when the amp is on, and

can flash diagnostic codes as required. The badge may be

rotated in 90 degree increments to suit any installation.

To access the controls on the top of the amp, remove the four

screws in the badge and set them in a safe place. Remove the

badge and set it in a safe place. The amp shroud can now be

removed for tuning and installation.

Note: Amplifier shown represents X2-Series amplifier.

Dimensions are not to scale.

FUSE 40 AMP X 6

SIGNAL

DETECT

OFF

CROSSOVER

FREQ Hz

SIGNAL

DETECT

CROSSOVER

FREQ Hz

Auto-Detect Monitors

the top INPUT ONLY

TURN ON

FUSE 30 AMP X 2

+12 V

GND

PWR \ PROT

Not Used with

Auto-Detect

DETECT

OFF

INPUT

SLAVE IN

REMOTE

LEVEL

SLAVE

OUT

Page 7

+12 V

SUB

1Ω MIN