ARC Audio XDi 450.4 소유자 매뉴얼 - 페이지 5

{카테고리_이름} ARC Audio XDi 450.4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARC Audio XDi 450.4 11 페이지. Full range class d amplifier

Bass Boost

This amp has an adjustable Bass Boost that is directed to the front speakers. When laying out your system, if you plan to

use Bass Boost (Example: Running a Bridged Subwoofer), connect those speakers to the front channels. Begin your adjust-

ments at a low volume. If you do not hear any improvement

then the woofer does not need any boost. Use Bass Boost

carefully. The demands on power output are tremendous.

Try to minimize the use by changing woofer position or the

enclosure size.

This amplifier operates in the traditional sense with regard to Ohm loads. Lowering the Ohm load will increase power

output however it will also increase current draw and produce more heat. This amplifier is capable of running any mix or

combination of Ohm load on the front and rear channels. They do not have to be the same.

Any speaker or combination of speakers with a total combine Ohm load between 2 and 4 Ohms can be used on any single

channel.

Bridged loads must not drop below 4 ohms but my exceed 8 Ohms if needed. This will not damage the amplifier however

power output will decrease at higher load.

WARNING: This amplifier will not operate and could be

damaged if used in the wrong configuration. At no time

can it be operated below 2 Ohms stereo or 4 Ohms

bridged.

This amplifier is a multi channel amplifier design. Meaning it has more than one channel of speaker outputs. It is

equipped with a removable plug style terminal for speaker wire connections up to 14 AWG. Make this connection

carefully and neatly. Strip your wire back 5/16" and twist the exposed leads and insert them into the block terminal while

being careful that there is no loose or frayed strands of wire.

Tighten the standard head screw down on the terminal until

the wire is tightly secured in place. If the wires ever come in

contact with each other the amplifier will go into protection.

Know your total ohm load before you make any connec-

tions.

Strip Speaker Wire

16 "

8MM

BASS

HP FREQ Hz

LP FREQ Hz

BOOST

FREQ Hz

INPUT

GAIN

MIN

Top