Cino FuzzyScan F780 Series 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Cino FuzzyScan F780 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cino FuzzyScan F780 Series 17 페이지.
Cino FuzzyScan F780 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)

페이지 인쇄

Force Mode

When force mode is selected, the light source of the scanner is forced on for

continued operation without having to press the trigger switch. This mode is

convenient for high speed bar code reading.

Toggle Mode

When toggle mode is selected, you must press the trigger switch to turn on

the light source of the scanner to start scanning operation. The scanner

keeps the light source on until you press the trigger switch again. This mode

is very similar to alternative mode but without the preset light source on time

concern.

Diagnostic Mode

When diagnostic mode is selected, the light source of the scanner is forced

on without regard for other programmable parameters, such as reread delay,

redundancy, and so on.

Low Power Mode

When low power mode is selected, the scanner goes into idle state after

scanning the bar code. You must press the trigger switch to wake up the

scanner for operation.

Multiple Read Mode

When multiple read mode is selected, the scanner is allowed to decode

multiple bar codes with a single pull of the trigger. When you press and hold

the trigger to aim at a series of bar codes, the scanner will decode each bar

code and beep for each good read. For more precise bar code decoding, you

are recommended to enable Center Alignment function while multiple read

mode is selected. You also can enable Unique Bar Code Reporting function

to report only unique bar code when the scanner trigger is pressed. For the

setting of Center Alignmen and Unique Bar Code Reporing, please refer to

Programming Manual for details.