Cino FuzzyScan L680BT 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} Cino FuzzyScan L680BT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cino FuzzyScan L680BT 17 페이지. Cordless scanner
Cino FuzzyScan L680BT에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)

페이지 인쇄

Use FuzzyScan in HID Mode

Ensure the battery is fully charged. Power on the scanner within radio

coverage and ensure the status indicator of scanner gives alternative

red and green blinks (in "Uninstall" state). If your scanner is not in the

Uninstall state, please scan the "Uninstall" command first.

If your remote host is equipped with latest Bluetooth drivers, or it's an iOS

or Android device, it is recommended to use "HID Mode".

Once you had scanned the "HID Mode" barcode, the scanner's link

indicators will blink blue 3 times every 2 seconds during the search

process. You have to execute the Bluetooth Discovery procedure to find

nearby Bluetooth device, then select "F(L/A)xxxBT-xxxx" (the xxxx are the

last 4 digits of its MAC address).

The scanner will emit 4 beeps in ascending tone to indicate the

connection is established. The scanner's link indicators will also flash

blue every 2.5 seconds to indicate a radio-connected state.

If the scanner is not pair with the host device within 1 minute after

scanning the above command, it will enter radio-off state automatically.

You can wake up the scanner by pressing its trigger, this will also cause

the scanner to re-attempt pairing.

The installation procedure may vary depending on different remote

host devices, operating systems and the Bluetooth drivers. Please

consult your professional IT consultant to obtain necessary support.

Uninstall

HID Mode