Arc-Family Arc4Sports 사용자 설명서 - 페이지 5

{카테고리_이름} Arc-Family Arc4Sports에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Arc-Family Arc4Sports 11 페이지.

Charging the Delivery Unit

Only use the Plug Charger supplied.

Insert the lead of the Plug Charger into the base of the Delivery Unit, then insert the Charger into

a wall socket, and switch ON. You will hear two short beeps. The left-hand button will indicate

Amber, as will the LED of the last Treatment Option delivered.

After a few seconds the button will begin to flash Amber and will continue to do so until the unit

is fully charged. A full charge takes approximately 4 – 5 hours.

During charging, the battery charge status will be indicated by the LEDs (1 – 4)

n n n n n n

charging first quarter

n n n n

charging second quarter

n n

charging third quarter

n n n

charging fourth quarter

n n n n

charging complete. Remain flashing for 5 minutes

When the left-hand button has turned green your unit is fully charged and can be unplugged.

When your Delivery Unit is unplugged you will hear a beep to indicate that the unit is OFF.

A full charge will enable approximately 35 hours of treatment delivery.

Note: The Delivery Unit is supplied with the Audible Beep Alert ON.

If you require this function turned OFF, go to Page 4.

(Left button flashing amber)

(Left button flashing green)

Always ensure that the Delivery Unit is switched OFF (if it has not already automatically turned

OFF). Place the sticky Electrode Pads back onto the plastic sheet.

The Electrode Pads have been specifically designed for comfort and connectivity. They are fixed

to the Arm Strap with 2 press studs. The Electrode Pads are water based and can dry out if left

out in the open. If they lose their adhesive quality in this way, it is possible to reactivate their

adhesiveness by applying a fine spray of water. Replace the Electrode Pads when they stop sticking

as this can affect the connectivity of the Delivery Unit. They should be removed after each session.

Useful Tip – to best preserve your Electrode Pads and for ease of use - on first use, cut the plastic

film in half then, with film still in place connect to press studs on Arm Strap. Remove plastic film

before applying to the skin. At the end of each Treatment delivery, replace plastic film on pads

while not in use. This keeps them clean and maintains adhesiveness.