Accurate Technology Digi Scale Model 10 사용자 설명서 - 페이지 15

{카테고리_이름} Accurate Technology Digi Scale Model 10에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurate Technology Digi Scale Model 10 17 페이지.

Frequently Asked Questions

What F/W (Firmware) version do I have?
The display will show P1.xxx on power up. This is the firmware version that your
Readout uses.
What does "Err2" mean?
If the Encoder is off the scale, or the Encoder cable is unplugged from the Readout,
ERR 2 will appear on the display. To clear error:
1. Be sure the Encoder is on the scale.
2. Unplug the connector from the Readout for one second and reconnect..
What does "Err4" mean?
Attempting to display measurements over 99 inches in fractions:
This digital Readout will only read up to 99 63/64 in fractions mode. You must use
either the decimal or metric modes when measuring over 99 63/64 inches.
The keys don't seem to do what they are supposed to do.
Timing, that is how long a key is depressed, and the combination of the keys pressed is
important.
This manual uses the term '"momentarily" to describe a key press of
typically less than 1 second. Whereas "press and hold" is used imply a key press of
typically longer than 1.5 seconds. As an example; when using a PC keyboard to type a
capital letter you would "press and hold" the SHIFT key and "momentarily depress the
LETTER key.
In addition, keep in mind the key(s) "function" is executed on the key RELEASE, not
the key DEPRESS. This is important since some keys execute different functions
based on how long they are depressed.
The battery clips seem to be very loose. Is this normal?
Yes. DO NOT attempt to bend these clips or wedge anything between them and the
case. These clips are designed to expand when the two case halves are screwed
together.
The readings are "backwards"?
You can change the "scaling" direction of the system by:
1. Reversing the orientation of the Encoder on the Scale
2. Changing the position of Jumper JP1 on the circuit board
Accurate Technology Digi Scale
Page 15 of 17