Accurate Technology DigiStop-10 설치 및 운영 매뉴얼 - 페이지 16

{카테고리_이름} Accurate Technology DigiStop-10에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurate Technology DigiStop-10 20 페이지. Digi-stop series

페이지 인쇄

Programming Parameters

The readout programming parameters are listed below.

Values in [ ] are the available range of values that can be entered for that

parameter. Factory defaults are shown in

NOTE: Programming parameters are not sequentially numbered due to firmware

differences between measurement systems and the provision for future

enhancements, functions and custom features.

Some Parameters are not applicable to all Digi systems.

Pr 1 – Datum Key

The programmed value that will be recalled whenever the

pressed during normal operation.

Default = 0.00

Pr 2 – Reverse Readings

This parameter controls the direction of travel (positive vs. negative) when the

encoder is moved.

Default = 0

Pr 3 – Key Lockout

This parameter controls the operation of the +,

If enabled, (set to 1), these keys will not function and the LOCK symbol will

appear on the display. This prevents accidental changes when pressing these

keys during normal operation.

Default = 0

Pr 4 – Readout Resolution

This parameter sets the number of places to the right of the decimal point on

the readout.

A value of 1 – Low - will display x.x.

A value of 2 – Normal -will display x.xx

A value of 3 – High - will display x.xxx

Default = 2

NOTE:

Millimeters have a maximum of 2 places (even if parameter is set to 3.)

This setting has no effect when displaying fractions.

Pr 5 – Wake Up Movement

This parameter sets the amount of Stop movement required to automatically

wake up the Readout (when it is turned off or in sleep mode).

Default Value = 0.10mm

Manual Part # 800-1070-001 Rev 10-2016

Bold

to + 999.999in] or

Red.

to +9999.99mm]

DATUM

and

keys.

DATUM

[0.10 to 10mm]

Page 16 of 20

key is

or 1]

[1, 2, 3 or 4]