Arcade Guns G-500 사용자 설명서 - 페이지 9

{카테고리_이름} Arcade Guns G-500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcade Guns G-500 20 페이지.

We aren't going to talk too much about the command line version of MAME which

should only be used by people who know a little bit about MAME already; mainly

because it requires additional knowledge about running command line arguments. Just

in case you are interested it would go something like this:

1) Download and unzip MAME into a directory of your choice on your computer.

2) Start->Run->Type "cmd".

3) Use the command prompt window to find the directory that MAME is located

on your computer.

4) Type "mame.exe -createconfig" which will create the mame.ini file.

Next we will want to open the mame.ini file in a text editor such as WordPad. We are

going to make some updates to the following entries. Some of them will already be set

correctly by default and some will not. Make the necessary updates to your mame.ini file

so that they match the following entries:

mouse

joystick

lightgun

multimouse

offscreen_reload

lightgun_device

mouse_device

dual_lightgun

By default your light guns are configured to work in mouse mode for cursor x and y

movements. If you change your light guns to work in joystick mode for the cursor

movements then you will also need to set the dead zone to 0 in your mame.ini file:

joystick_deadzone

This concludes our MAME section in this manual. To continue configuring MAME open

the Ultimarc AimTrak Setup Guide and start reading from page 11.

Arcade Guns™ User Manual

none

mouse