CipherLab 1166 매뉴얼 - 페이지 4

{카테고리_이름} CipherLab 1166에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CipherLab 1166 6 페이지. Bluetooth scanner

Barcode Transmission Speed

If data transfers too fast for the software to accept, try the following:

First – Scan Enter Setup

Second – Select one of the following speed options (Note: 500ms recommended, 1 sec or slower for Thin Client).

Scan one barcode for your required speed option.

500ms

Default (no delay)

Last – Scan Update

Other Points to note: User Choice Memory Mode

•

Data remains in the memory until deliberately removed using the steps in Clear data from memory (previous page)

•

If battery becomes low during stocktake a green light will appear on scanner. Labels scanned prior to loss of battery

power are retained in the memory. Change batteries or recharge by returning scanner to the cradle.

•

Scanner is not required to be in cradle for downloading data from memory, just in receiving range. You may prefer to

be at the computer to view downloads.

•

Consider transferring to a text file first, in case of software malfunction

Buzzer Setting (Sound Volume / Frequency)

All Barcodes Australia has set to 2 kHz.

Please note this will adjust the scanning volumes / frequency only. It cannot adjust factory settings which alert program

changes etc.

Alter by experimenting with one of the following :

Step

Action

Scan Enter Setup

Select one of the following buzzer

setting options. Scan one

barcode to listen to your required

buzzer option

Scan Update

2 sec

1 sec

Barcode

8kHz

Page 4 of 4

3 sec

4kHz

2kHz

5 sec

1kHz