Accurate Technology VALIANT 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Accurate Technology VALIANT에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Accurate Technology VALIANT 10 페이지. Twin drag reel

VALIANT

ATD

Drag

Thanks to the Valiant's exclusive TwinDrag technology, the drag tension you set will vary no more than one pound when

line is pulled off the reel at any speed! Unfortunately, there is another factor which causes drag variance that needs to

Variance

be accounted for . This factor is based on how full the reel is with line . When the spool is filled, the line is being pulled off

a high point on the spool . As the amount of line on the spool reduces, the line is pulled from a lower area on the spool .

There is less leverage used when the line is pulled at a lower level, which means the line needs more force to move the

spool against the drag . The drag setting has not been decreased, but the line will encounter increased tension . Account

for the drag pressure to approximately double when 25% of the line has been removed from a full spool .

Filling

Begin filling the Valiant reel by attaching the line securely to the reel spool . With tension applied to the line, fill the spool

to approximately 1/4" from the spool edge .

the Spool

NOTE: Filling the spool too close to the spool edge means you will have to level wind perfectly to prevent a high spot from

occurring . If a high spot occurs, the reel will not allow you to retrieve all of the line . Leave room on the spool to level wind

comfortably while fighting a fish .

Because of mono compaction when using ultra light line, we recommend first filling the spool with at least 2/3 spectra

line . Mono Compaction - Mono compaction is a problem that happens with light line . The smaller the mono line

diameter, the more elasticity the line will have . The elasticity is multiplied by the amount of line put on the spool

which creates pressure on the spool . When too much light line is added,

the pressure can expand the spool . This could cause the reel to

perform with inconsistent drag pressure or, if enough pressure

is built up, break the spool in half .Always put the least amount

of ultra-light line on the reel as needed .

Rod

Mount the reel on the rod with its rod clamp .

If your reel is a right-handed model, be sure to

Mounting

mount the reel with the handle on the right .

Rod Clamp