Arcam DiVA P85 핸드북 - 페이지 4

{카테고리_이름} Arcam DiVA P85에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcam DiVA P85 14 페이지.

페이지 인쇄

Installation: A85 integrated ampliﬁ er

VOLTAGE

SELECT

POWER INLET

Positioning the unit

Place your ampliﬁ er on a level, ﬁ rm surface.

Avoid placing the unit in direct sunlight or near sources of heat

or damp.

Ensure adequate ventilation. Do not place the unit in an

enclosed space such as a bookcase or cabinet as both of

these will impede air ﬂ ow through the ventilation slots.

Connecting to loudspeakers

You can connect one or two pairs of loudspeakers to your

ampliﬁ er, provided each pair is rated between 8–16Ω. If one or

both pairs have an impedance of less than 8Ω, the combined

load on the ampliﬁ er falls below 4Ω and could cause an

overload. If so, the overload protection circuit engages and the

ampliﬁ er will not work.

To connect one pair of loudspeakers, use the

SP1 and SP2 terminals

Both sets of loudspeaker terminals can be switched off by

pressing the

and

page 6) or the remote control (see page 9).

Your ampliﬁ er is ﬁ tted with loudspeaker terminals to BFA

(British Federation of Audio) standard speciﬁ cation.

The terminal will accept spade terminals, bare wires or a

BFA plug. BFA plugs are available from your Arcam dealer. To

connect a bare wire or spade terminal, unscrew the red (or

black) part of the loudspeaker terminal ﬁ rst.

Insert the wire or spade terminal and screw it back up.

CAUTION: Do not over tighten the loudspeaker terminals or

use a wrench, pliers, etc., as this could cause damage to the

terminals which will not be covered under warranty.

A85/P85

SP2

4 – 16 OHMS

TRIG

OUT

SP1

REMOTE

–

button on the remote control. To switch

MUTE

independently, use the front panel switch

SP2

BFA loudspeaker terminals

INTEGRATED

–

PRE/PWR

PWR IN

PRE OUT

Connect the right speaker to the terminals on the back of

your ampliﬁ er marked

marked

Connect your loudspeakers so that the red (positive/+) terminal

on each loudspeaker is connected to the red (positive/+)

terminals.

terminal on the ampliﬁ er. Your loudspeaker cables may be

SP1

marked to show polarity (negative/– and positive/+), if not, then

the positive terminal can usually be identiﬁ ed by a ridge or

coloured marking.

SP1

Now connect your loudspeakers' black (negative/–) terminals to

(see

the black (negative/–) terminals on the ampliﬁ er.

Ensure that no stray strands of inner wires are allowed to touch

another cable or the ampliﬁ er's casing. This can cause a short

circuit and damage your ampliﬁ er!

RECORD

PLAY

RECORD

PLAY

OUT

TAPE 1

VCR/TAPE 2

DVD

8 9 bk bl bm bn bo bp

Arcam A85 amplifier

–

Right

speaker

Wiring your loudspeakers

and the left speaker to the terminals

PHONO

TUNER

AUX

–

Left

speaker