AXTON A1300 설치 및 운영 매뉴얼 - 페이지 3

{카테고리_이름} AXTON A1300에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AXTON A1300 20 페이지. Car audio system 1-/2-/4-channel power amplifiers

1. CONNECTIONS + CONTROLS A295

1.1 CONTROLS

RCA INPUTS 1/2-CH

Low-level stereo RCA signal input 1/2-CH for connection to head-unit.

Input gain potentiometer for channel 1/2-CH, to match the output voltage of the head-

unit to the amplifier's input.

Molex connector terminal to insert the High level adapter (4-pin) that picks up the

amplified speaker signal from the head unit's front output (if head unit does not feature

dedicated RCA line outs).

Slide switch to select the operation mode of the X-over for section 1/2-CH of the

amplifier.

X-OVER FREQUENCY CONTROL 1/2-CH

Control potentiometer to adjust the highpass or lowpass filtering frequency for

section 1/2-CH of the amplifier.

1.2 INPUTS + OUTPUTS

POWER LED

LED to show "operating" status of the amplifier by green/red illumination. Green is

normal working state, red is protect state of amplifier.

"GND" POWER INPUT TERMINAL

Terminal to connect the amplifier to the chassis ground or negative pole of the car

battery.

"REM" INPUT TERMINAL

Terminal to connect the amplifier to the automatic (remote) turn-on / turn-off lead of the

head unit.

"+12 V" POWER INPUT TERMINAL

Terminal to connect the amplifier to the positive +12V pole of the car battery.

10 ATC FUSE HOLDER

Fuse holder for 2 x 20 A ATC fuse. Never deploy fuses of higher amperage rating.

11 SPEAKER OUTPUT TERMINAL

Output terminal to connect the speakers to the amplifier in either stereo or bridged

mode.

– 4 –

1. CONNECTIONS + CONTROLS A295

6 7

4 5

8 9

– 5 –