AccuRelief ACRL-9100 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} AccuRelief ACRL-9100에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AccuRelief ACRL-9100 2 페이지. Wireless 3-in-1 smartphone or tablet. pain relief device
페이지 인쇄
Wireless 3-in-1
Pain Relief Device
Model ACRL-9100
KNOW YOUR DEVICE
LCD DISPLAY
Intensity increase
Treatment program
select: Neck/
Shoulder/Arm/
LBack/Joint/Leg
Tap/Knead/Rub
Remote Controller
Power supply:DC3.0V(2xAAA)
Manufactured for:
Compass Health Brands Corp
IP22
Power on/off button
1
Two AAA batteries are included.
Remove the back cover of
remote control by pressing
and sliding the cover in the
direction of the arrow. Insert
batteries as marked in unit.
Slide cover back into position.
2
Intensity
decrease
Each gel pad is pre-fixed
with a stud to connect to the
Power
back of the device, and is
ON/OFF
protected by a transparent
button
film. Attach the gel pads
Mode select
to the back of the device,
(TENS/EMS/
pressing them in place.
MASSAGE)
3
Clip excess hair from the area
to be treated. Wash with soap
and water, and dry completely.
Remove the protective film
layer and apply the gel pad
to the skin. Press firmly to
Battery cover
ensure adhesion.
4
Press the power button on the
ACRL-9100 unit to turn on.
A steady green indicator
light will turn on to let you
know the unit is powered
on and in standby mode.
Apply pads to normal, healthy, clean and dry skin of adult patients because it may
otherwise disrupt the healing process.
If you experience any skin irritation or redness after a session, do not continue
stimulation in that area of the skin.
INSERT BATTERIES
CONNECT THE GEL PADS
TO THE DEVICE
PLACE THE GEL PADS
ON THE SKIN
TURN ON THE
ACRL-9100 UNIT
QUICK START GUIDE
5
OPERATING THE
ACRL-9100 UNIT
Press the Power/Mode button on the remote
to connect to the electrode unit. Press Mode
again to switch between TENS, EMS and
Massage. Press Program to select treatment
area for TENS & EMS or select Massage
program. Use the ▲ and ▼ buttons to
increase and decrease the intensity of each
treatment.
6
TURN OFF THE
ACRL-9100 UNIT
Hold down the power button on
the remote until it turns off. Press
the power button on the electrode
unit to turn off. Make sure the
device is turned off before
removing the electrodes.
Recommended Gel Pad Positions
CH1 CH2
PROGRAM
M
/MODE