CIPTON CPTN1032 사용자 설명서

{카테고리_이름} CIPTON CPTN1032에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CIPTON CPTN1032 2 페이지. Led basketball

페이지 인쇄

READ CAREFULLY AND KEEP THIS CARD

General Warnings

• Do not use in the rain, sleet or snow. Keep away from water and extreme temperatures.

• Adult supervision is required when performing any maintenance on the ball.

• The ball comes with built-in batteries which should not be disposed of with regular

household waste. Follow all local laws and regulations in disposing of batteries.

Setting Up

• The ball comes with batteries already installed. Pull the tab marked "PULL" to remove

the spacer insulating the batteries.

• To activate the lights, bounce the ball. The lights are impact-activated.

• If the spacer is broken and cannot be pulled out, or if the ball does not light up after

the spacer is removed, try following the steps in the Replacing the Batteries section

below to re-install the light unit or replace the batteries.

Replacing the Batteries

CAUTION: Do not sure a sharp tool to open the cap. It is recommended to use a key.

These procedures should be done carefully, under adult supervision ONLY.

Keep all batteries, wrenches, plastic bags and other accessories away from babies,

children and pets. They are NOT toys. They can cause injury, su ocation, poisoning or

other dangers.

STEP 1

De ate the ball slightly and

use a non-sharp tool such as a

key to pry open the end cap.

Do not use a sharp tool as this

many damage the ball.

STEP 4

Use the tool to push the

batteries out of the unit

as shown above.

Instructions continued on back of page

LED Basketball

CPTN1032

STEP 2

Use the hook of the tool to

pull out the light unit.

STEP 5

Insert 3 new LR44 coin cell

batteries with the positive poles

facing down. Do not mix old and

new batteries, or mix di erent

types or brands of battery.

STEP 3

Pull the transparent tube

containing the batteries

out of the unit.

STEP 6

Place the transparent tube

of batteries back into the

light unit.