Arcam Alpha 8SE 핸드북 - 페이지 4

{카테고리_이름} Arcam Alpha 8SE에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcam Alpha 8SE 8 페이지. Arcam cd player handbook
Arcam Alpha 8SE에 대해서도 마찬가지입니다: 핸드북 (8 페이지), 핸드북 (8 페이지), 핸드북 (8 페이지)

Arcam Alpha 8SE 핸드북
Using your CD player - getting started
continued
REPEAT
123456789
10
DISPLAY
Dims or turns the display off and on. Turning the display off will
generally give a slight improvement in sound quality. Pressing
'DISPLAY' once turns the display off. To dim the display press the
'DISPLAY' button twice. To restore the display to full brightness
press 'DISPLAY' a third time.
REPEAT
To repeat the entire CD or a pre-programmed selection of tracks
press 'REPEAT' once. 'REPEAT' will illuminate on the display.
To repeat one particular track go to the track you wish to repeat
by using the ^ or H buttons (or the 0-9 keypad on the
remote control) and press 'PLAY'. Then press the REPEAT button
twice so that 'REPEAT I ' is illuminated on the display.
If you now select a different track, that one will be repeated
instead. To cancel the repeat function press 'REPEAT' a third time.
PROG
To programme a selection of up to 24 tracks from a disc in any
order To program your choice of tracks press Track
\<
or H ,
or use the remote's 0-9 keypad orTrack H and H buttons, to
locate the desired track.
Press 'PROG'to program the track into memory (RMS is illuminated
on the display to indicate that you have begun a programmed
sequence). Repeat these steps to program all the desired tracks
into the player The display will show the track numbers that have
been programmed, the total length of the programmed sequence
and how many tracks have been programmed by use of the
number above the word 'STEP'.
If you press H or H or use the 0-9 keypad to direct dial to a
track the number above the 'STEP' will change by one and start to
flash until you press 'PROG'. After pressing 'PROG' the number
will stop flashing. If you fail to press 'PROG' within about 5
seconds the display will also stop flashing and you will have to
reselect the track you want to program.
Press 'PLAY' to start playback of the programmed tracks.
The existing program may be replayed by pressing 'PLAY'.
To clear the programmed sequence of tracks press STOP twice.
CHECK
To confirm your programmed sequence, press 'CHECK'.
The first programmed track number and track time will be
displayed. Subsequent pressing of the 'CHECK' button will display
the next track details and total time of the sequence so far.
After checking the last selection 'END' is displayed for a few
seconds. The display then reverts to showing the track details of
the last programmed track.
c