Creative sysUSA ChoiBox Series 운영 매뉴얼 - 페이지 7

{카테고리_이름} Creative sysUSA ChoiBox Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Creative sysUSA ChoiBox Series 7 페이지. Logic interface box for multicolor led indicator with soft switch input

페이지 인쇄

PIN OUT Information

RJ45

PIN 1 – Additional Switch Input (future)

PIN 2 – RED LED

PIN 3 - GND

PIN 4 - +12V

PIN 5 – Switch Logic Control

PIN 6 – Green LED

PIN 7 – Blue LED

PIN 8 – TTL Logic output

5pin Phonix connector I/O control port

Pin1 : Input GND (System Ground )

Pin2 : Input Remote ( Open/High = Inactive; Low = Active)

Pin3 : Input LED Input ( Default colors: Open/High = Red LED; GND/Low = Green LED )

Pin4 : Switch Out Open collector (Pin4 Logic level changes to LOW when any button is pressed)

Pin5 : Logic Input (Default color: GND/Low = Blue LED, solid or blinking based on Dip SW10)

Note: Input Voltage 0V ~ 2V is considered LOW, 2.1V ~ 12V or open is considered High

TEST Button

Test1: Press "REMOTE" →Same as when I/O Pin2 is LOW. RED LED will light up.

DIP SW 1,2,3 combination can change the LED color. RED is the default set.

Test2: Press "REMOTE" and "LED/LOGIC" →Same as when I/O Pin2,3 is LOW.

GREEN LED will light up.

DIP SW 4,5,6 combination can change LED color. GREEN is the default set.

Test3: Press "LED/LOGIC" →Same as when I/O Pin5 is LOW. BLUE LED will blink.

DIP SW 7,8,9 combination can change LED color. Blue is the default set.

Period knob can change blinking speed.

DIP SW 10 mode switch position: UP = blinking; DOWN = solid