Arcam AVR20 사용자 설명서 - 페이지 12

{카테고리_이름} Arcam AVR20에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcam AVR20 18 페이지.

23425

AVR10/AVR20/AVR30/AV40 Software Release Notes

Host Version 1v10/09

LCD/IAP 0.50/0.04

DSP1 02.01 / 01.19

DSP2 00.01 / 00.17

DTS 3.90.50.1

OSD 0.03

DAB 303 / 561

NET 0.100.406

BT 0.7 (or higher, depending on build)

Fix list:

IMS20890: IMAX fixes applied.

IMS20955: Show streaming service logo & MQA logo when using Cast.

IMS21115: PS4 2 channel PCM using Virtual:X could cause audio artefacts

IMS21118: Sampling frequency incorrectly shown for analogue processing modes.

IMS21136: Sub trim does not show on OSD

IMS21208: When in standby, control commands for input switching should respond with 0x85

IMS21310: Bi-amp L/R speakers not recognised by Dirac calibration tool.

IMS21363: Cannot set display brightness over RS232/IP

IMS21369: When Dirac is enabled, speaker distance should show "mS".

IMS21371: Audio button toggles filter1, filter2, filter3, off.

IMS21372: Menu > Speaker Distance Sub shows as "Channel 12"

IMS21375: No OSD popup when Dirac EQ selected.

IMS21378: Dirac filters optimisation.

IMS21383: Start Dirac, unit would occasionally not got into Dirac measurement mode

IMS21384: Report Subwoofers as "sub" not LFE in Dirac calibration tool.

IMS21390: OSD shows "centre" and "analogue" when region set to US/Canada.

IMS21396: Start Dirac if on the NET input, test tones only come out of FL0

IMS21409: Audio button recalls current state on first press, then changes.

IMS21437: Cannot set IMAX Enhanced mode over RS232/IP

IMS21447: Editing name on unit after setting with web GUI causes crash

IMS21453: Dirac master volume level starts at incorrect level

– 12 –

Arcam, The West Wing, Stirling House, Waterbeach, CB25 9PB, UK