Axxent AX1400TS 사용자 설명서 - 페이지 3

{카테고리_이름} Axxent AX1400TS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxent AX1400TS 4 페이지. Professional power amplifier

user manual

models AX-1121TS / AX1240TS / AX 1400TS

Amplifier controls and connectors on the rear

At the far left you see a large power switch and below an IEC con-

nector with fuse holder. Intentionally we do not use an integral

power cable so that the amplifier may be removed from a 19" rack

easily. The IEC power cable is always included in the amplifier box,

when shipped.

If you should ever encounter an amplifier problem, i.e. you have

switched it on and the green power led does not light, its fuse

may be defective. A defective fuse should be changed by a quali-

fied service technician. Power fuse values are as follows: AX1121T

and AX1240T slow blow 4 A; AX1400T slow blow 6.3 A. Fuse type

5 mm by 20 mm.

Output Connectors, constant voltage

To the right of the power switch you can see the green Eurobloc or

Phoenix connector. This connector is used for the constant voltage

outputs and indicated 50 v, 70 v, and 100 v. Standard constant volt-

age in Europe is 100 v.

The Eurobloc is a solderless connector that uses screw terminals to

connect wires. Once the wires are installed, the entire assembly is

plugged into a matching socket in the electronic device. Euroblocs

are more convenient than terminal strips because they may easily

be disconnected if the need arises.

axxent e.K. • Technologiezentrum Herzbachtal • Zum Wartturm 15 • 63571 Gelnhausen

Fon: +49-6051-9165584 • Fax: +49-6051-9165585 • [email protected] • www.axxent.de