Axxent GMX-2500 운영 매뉴얼

{카테고리_이름} Axxent GMX-2500에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxent GMX-2500 4 페이지. Gastro-mixer

페이지 인쇄

GMX-2500 setup and operation

When opening the box, you should find:

• The mixer GMX-2500

• The 19" rack mount brackets (pre-installed)

• Equalizer protective cover plate (pre-installed)

• Two adapters: phone/RCA for the front line inputs

• Powercord

Unit dimensions:

435 mm x 280 mm x 88 mm (without rack mount brackets)

Weight:

4.4 kg net, 5.9 kg shipping

After unpacking the mixer please plug in the delivered

power cord into the power input jack of the unit. Before

connecting the mixer to the wall outlet, make sure that the

"POWER" switch on the right of the front side is in "OFF"

position. Also the main volume control (MASTER) should

be set fully counterclockwise ("0" position).

Attention: Due to safety reasons the case never should

be opened by the user. Beside, this also may void any

warranty claims!

Now you may connect the mixer to a wall mains outlet.

Please make sure you first switch on the GMX-2500 and

then the power amplifier. This way you avoid annoying

audible transient noise.

Josef Becker Pro Audio Technik · Technologiezentrum Herzbachtal · Zum Wartturm 15 · D-63571 Gelnhausen

Fon: +49-6051-9140-0 Fax: +49-9140-59

[email protected] · www.proaudio-technik.de

Gastro-Mixer GMX-2500

Operation Manual

controls on the front side

On the left hand side you will find the 3 pin XLR female con-

nectors (1), the microphone inputs for connecting balanced

microphones. Close by on the right is a recessed push

button (2) for activation of phantom power when using

condenser microphones. When dynamic microphones

are hooked up, the switch remains in the "OFF" position.

Please note, that the microphone inputs on the front and

on the rear side are used in parallel. This means that you

may either use the front- or the rear inputs, not both of the

XLR input pairs simultaneously.

Beneath the XLR inputs you will find two 1/4" phone jack

inputs (3). These are line level inputs, for example to con-

nect a stereo keyboard or a device for playback music. The

left phone jack is a stereo type (TRS)

e.g. tip = left channel, ring = right

channel input. When using mono

phone plugs connect left and right

plugs as printed on the housing. In

case you want to use a cable with

RCA connectors, we have enclosed

two suitable adapters in the packag-

ing for your convenience.