3Com CoreBuilder 9000 설치 매뉴얼 - 페이지 7
{카테고리_이름} 3Com CoreBuilder 9000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com CoreBuilder 9000 13 페이지. 16 mb expansion memory card installation guide enterprise switch
3Com CoreBuilder 9000에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 제거 및 교체 매뉴얼 (12 페이지), 설치 매뉴얼 (13 페이지)
페이지 인쇄
GBIC Disable Error
If the system detects that the transceiver cannot emit the proper laser
signal, it disables the port, sets the port type to
description (
The following message appears in the event log:
Due to excessive TxFault conditions, GBIC Port xx has been
disabled.
Excessive Tx Fault conditions indicate a faulty GBIC.
Meaning
Replace the transceiver. If the problem persists, contact network supplier
Corrective action
or 3Com Technical Support. For contact information, see the Technical
Support appendix in the Getting Started Guide for your system.
"Unapproved GBIC" Error
Supported transceivers are those that 3Com has specifically tested and
qualified for use with 3Com GBIC systems. Pretesting at 3Com ensures
proper functionality, compatibility, and regulatory compliance.
If the system detects a transceiver that 3Com does not support, it sets the
port type to
(
Unappr.GBIC
WARNING
The GBIC in Port xx is NOT approved by 3Com & may violate
electromagnetic emission or safety requirements for your
country. Refer to 3Com's web page
(www.3com.com/gigabit_ethernet/gbics) for our current
approved list.
The following informational message is shown in the event log:
Unqualified GBIC: Unqualified vendor part number
Although this report does not necessarily indicate that the GBIC
Corrective action
transceiver will not function properly with the system, it does indicate
that 3Com has not qualified the transceiver and does not support it.
70-km Gigabit Ethernet GBIC Transceiver Installation Guide
), and captures the error in the event log.
GBIC Disable
Unqualified GBIC,
), and captures the error in the event log.
disabled
displays a short description,
7
, displays a short