digico SD7 기술 노트 - 페이지 9

{카테고리_이름} digico SD7에 대한 기술 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. digico SD7 11 페이지. Replacing and cleaning faders
digico SD7에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

TN198 Page 9 of 11

Continue to re install the Engine tray. Tighten the fixing screws to the rear panel of the engine once it

is fully home.

Next re connect the Video, Local I/O and Linkport ribbon cables, via the hole in the PC base plate

floor. This sometimes a little awkward, do not try to rush this.

Carefully fit spiral wrap to the optical cables in the top of the engine to ensure these are secured

neatly out of the way, as shown in the pictures above.

Screw down the engine tray with the internal fixing screws and re-fit the fan panel making sure that

the fan power is connected.

Replace the engine lid and re fit the engine into the console.

Repeat whole procedure for second engine

See next page for Software Upgrade Instructions

TN198.doc\