Axxera MINI AX460D 설치 및 사용 설명서 - 페이지 7

{카테고리_이름} Axxera MINI AX460D에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxera MINI AX460D 13 페이지. Mini series mobile power amplifiers
Axxera MINI AX460D에 대해서도 마찬가지입니다: 설치 및 사용 설명서 (13 페이지), 설치 및 사용 설명서 (13 페이지)

Speaker Connections
Connect speaker wires
observing polarity. The
minimum impedance load for
the AX460D and AX490D is
2 ohms stereo and 2ohms
bridged. Use of loads lower than
these is not recommended and
may cause amplifier damage.
The AX460D and AX490D can
be wired for stereo, bridged or
stereo/bridged simultaneous
operation.
Input Signal Connections
Low Level Input (RCA)
Low level (RCA) input signal is preferred for best performance. Typical trunk-mount
amplifier installations require a 17-20 foot RCA cable. Most trucks and under-seat
applications require a 6-9 foot RCA cable. Using twisted pair construction RCA
cables will minimize noise.
Note: Do not use both low and high level inputs
at the same time - connect only one or the other.
INSTALLATION

Amplifier Connections

2 Speakers (stereo)
Typical Stereo Wiring
(2 ohms minimum)
Typical speaker connections shown
High Level Input
(Speaker Wire)
High level inputs should only be used
when RCA outputs are not available
from the head unit. Connect the
head unit speaker outputs to
the high level input connector
as shown below. The black wire
(signal reference ground) may or
may not require a connection to
chassis ground - depending on your
particular installation.
Subwoofer (mono)
Typical Bridged Wiring
(2 ohms minimum)
L
R
7