digico SD7 기술 노트 - 페이지 11

{카테고리_이름} digico SD7에 대한 기술 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. digico SD7 11 페이지. Replacing and cleaning faders
digico SD7에 대해서도 마찬가지입니다: 매뉴얼 (9 페이지)

TN198 Page 11 of 11

8) Set the Setup>Audio Sync of the session to Optocore.

9) Connect the Optocore equipped rack to the relevant engine and loop number and set the ID of

the rack itself (eg Engine A – Loop 1 – Rack ID 30)

10) Check audio functionality of the inputs and outputs to the rack by selecting them in the SD7

channel routing panels under Port 5.

11) Repeat for the other engine if fitted.

Optocore Software Upgrade (if required)

1) Quit to Windows.

2) Right click on 'Start' and choose 'Explore all'

3) Locate the APP (D) drive and expand the view

4) Click on the SD7 folder to view its contents

5) Look for DI7_211.exe and run this

A window will open and you will see that the application has started communications with

Optocore via a serial Com port.

6) At the bottom of this window is a button 'Update Firmware' Click on this and wait for a message

to confirm the download is complete

7) Repeat for the other engine if fitted.

8) Re boot the console from power down.

TN198.doc\