digico S Series 매뉴얼 - 페이지 3
{카테고리_이름} digico S Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. digico S Series 9 페이지. Replacing and cleaning faders
페이지 인쇄
SD7Q / SD5Q / SD7 / SD5
This section is for the cleaning and replacement of faders in Quantum 7, Quantum 5, SD7 and SD5 consoles
only.
Part Numbers – see
Appendix 1 – Fader Table
•
Input fader: SC-SD7-FADERI
•
Master fader: SC-SD7-FADERL
•
Upper fader: SC-SD7-FADERM
•
Upper fader: SC-SD7-FADERML
Replacing Lower (100mm) Faders
1. Power down the console, switch off the PSU's
and connect your antistatic strap to an
appropriate earthing point.
2. Unscrew the fader panel (SD5 panel shown
opposite) with the 2mm Hex driver
3. Carefully tilt the panel and disconnect the
cables to the PCB's (SD5 card below with
arrows), and the fader connectors.
4. Carefully unscrew the fader driver PCB
retaining screws (SD5 card opposite with
screws indicated as yellow stars
fader driver card somewhere safe
5. Flip the panel back over and remove the fader
knobs and store them somewhere safe.
6. Use a Hex driver to remove the screws at the
top and bottom of the first fader, store them
somewhere safe.
7. Carefully remove the fader and place to one side.
8. Repeat the fader removal (steps 6 and 7) and place them to one side keeping the sequence of
faders, do not mix them up – label them if necessary.
9. Using the vacuum cleaner and the paintbrush, gently clean the panel, PCBs, and the area inside of
the console.
10. Install the new faders, screw down the fader driver PCB, plug the faders into the PCB, and carefully
re-plug the connectors to the PCB's. Place the fader panel back into the console, switch the console
on and test the functionality of the faders and buttons – the panel can now be screwed back into
place.
Cleaning Lower (100mm) Faders - Follow steps 1 – 9 above
11. Using a flat bladed screwdriver, gently prise the cover off the fader
12. Use the compressed air to dislodge any dust and dirt from the inside of the
fader assembly, then use the vacuum cleaner and paintbrush to remove the
dust and dirt. Repeat as necessary.
13. Lay the fader on paper towels, then with the fader at one
end of the track, spray the cleaner-lubricant on one of the
rails for no more than 1 second, repeat for the second rail.
TN 559 – Cleaning and replacing faders - All consoles
for full details
100mm Input fader with plug – SD7Q, SD5Q, SD7, SD5
100mm Master fader with plug – SD7Q, SD7
60mm Upper fader with plug – SD7Q, SD7
60mm Upper Master fader with plug – SD7Q, SD7
), store the
Page 3