Axxess ASWCSTALK 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Axxess ASWCSTALK에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess ASWCSTALK 16 페이지. Metra electronics automobile parts user manual

Programming the ASWCSTALK

* If this is the first time the ASWCSTALK is being installed:

1. Turn the ignition on; the led will start flashing rapidly which means the

interface is looking for the ASWCSTALK and the radio. Go to step 3.

* If the ASWCSTALK was installed before:

1. Turn the ignition on, the led will flash slowly

2. Hold down the reset button for more then 2 seconds but less then 10

seconds, the led will start flashing rapidly

3. The ASWCSTALK INTERFACE will automatically find the

ASWCSTALK and radio.

4. After a couple of seconds the led should stop flashing and not light up

for 2 seconds. At this point do not push any buttons.

5. After the 2 seconds there will be a series of 7 flashes, some short and

some long.

6. The led will pause for another 2 seconds then flash up to 10 times.

7. This is the end of the auto detection stage. If the ASWCSTALK

interface detected the vehicle and the radio successfully the led will

light up solid red.

8. Make sure the steering wheel control buttons function correctly in the

vehicle and enjoy your radio.

If the ASWCSTALK is mounted on the right side of the steering column

follow the instructions below. (Auto-detect must be done first)

Turn the ignition on

Press the MODE on the ASWCSTALK for 10 seconds

Then press volume up for 2 seconds