Axxess AX-AU12-SWC 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Axxess AX-AU12-SWC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-AU12-SWC 12 페이지. Data interface with swc for audi

Attention! This interface will work with models that are either Bose amplified, or non-Bose

amplified. Please follow the instructions carefully for your model vehicle. Failure to do so will

result in improper sound. If you are unsure if your vehicle is Bose amplified or not, please contact

your local dealership.

For models equipped with a Bose sound system:

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connect the Red wire to the accessory wire.

• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.

• Connect the Blue/White wire to the amp turn on wire.

Note: There is a Blue/White wire on the BX-AU2 harness to connect as well.

The following (3) wires are for multimedia/navigation radios that require these wires. If not

required, tape them off and disregard them.

• Connect the Blue/Pink wire to the VSS/speed-sense wire.

• Connect the Green/Purple wire to the reverse wire.

• Connect the Light Green wire to the parking brake wire.

• Tape off and disregard the following (8) wires, they will not be used in this application:

Green, Green/Black, Purple, Purple/Black, White, White/Black, Gray, and Gray/Black.

CONNECTIONS TO BE MADE

(LD-BX-AU2 APPLICATIONS)

From the LD-BX-AU2 harness to the aftermarket radio:

• Connect the Black wire to the ground wire.

• Connect the Yellow wire to the battery wire.

• Connect the Blue/White wire to the amp turn on wire.

• Connect the White RCA jack to the left front RCA output.

• Connect the Gray RCA jack to the right front RCA output.

• Connect the Green RCA jack to the left rear RCA output.

• Connect the Purple RCA jack to the right rear RCA output.

Note: It is highly recommended that the radio being used has (2) sets of RCA outputs to

retain balance and fade; (3) sets if a subwoofer amplifier will be added.

• Tape off and disregard the following (8) wires, they will not be used in this application:

Purple, Purple/Black, Green, Green/Black, Gray, Gray/Black, White and White/Black

Continue to 3.5mm jack steering wheel control retention