Axxess AX-HYKIA1-SWC 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Axxess AX-HYKIA1-SWC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-HYKIA1-SWC 12 페이지. Hyundai/kia datainterface withswc2010-2016

Button assignment legend

1. Volume-Up

2. Volume-Down

3. Seek-Up/Next

4. Seek-Down/Prev

5. Source/Mode

6. Mute

7. Preset-Up

8. Preset-Down

9. Power

* Not applicable in this application

Note: Some radios may not have these commands. Please refer to the manual provided with the

radio, or contact the radio manufacturer for specific commands recognized by that particular radio.

STEERING WHEEL CONTROL SETTINGS

10. Band

11. Play/Enter

12. PTT (Push to Talk)

13. On-Hook

14. Off-Hook

15. Fan-Up *

16. Fan-Down *

17. Temp-Up *

18. Temp-Down *

(CONT.)

Dual assignment (long button press)

The AX-HYKIA1-SWC has the capability to assign (2) functions to a single button, except Volume-Up

and Volume-Down. Follow the steps below to program the button(s) to the desired setting.

Note: Seek-Up and Seek-Down come pre-programmed as Preset-Up and Preset-Down for a

long button press.

1. Turn the key to the ignition but do not start the vehicle.

2. Press and hold the desired steering wheel control button for (10) seconds, or until the L.E.D.

flashes rapidly. At this point release the button; the L.E.D. will then turn a solid green.

3. Press and release the Volume-Up button the number of times corresponding to the new button

number selected. Refer to the Dual Assignment Legend. The L.E.D. will flash rapidly while the

Volume-Up button is being pressed, and then go back to a solid L.E.D. once released. Proceed

to the next step once the Volume-Up button has been pressed the desired number of times.

Caution: If more than (10) seconds elapses between pressing the Volume-Up button, this

procedure will abort, and the L.E.D. will go out.

4. Press the desired button to store it to memory. The L.E.D. will now go out indicating the new

information has been stored to memory.

Note: These steps must be repeated for each button desired to assign a dual assignment feature

to. To reset a button back to its default state, repeat Step 1, then press the Volume-Down button.

The L.E.D. will go out, and the dual assignment feature for that button will be erased.