Digicom 8 PORT 100 사용자 설명서 - 페이지 16

{카테고리_이름} Digicom 8 PORT 100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digicom 8 PORT 100 19 페이지. 8 port switch or hub

8 port 10/100

When extracting a cable never pull the cable itself but first press the tab and then pull the

connector.

Note:

When cascading hubs operating at 10Mbit/s, do not cascade more than 4 devices (IEEE 802.3

restrictions). When cascading hubs operating at 100Mbit/s, do not cascade more than 2 devices

(IEEE 802.3u restrictions). Also be sure that the total cabling length between two end stations does

not exeed 205 meters (672 feet). If two stations are connected to two different cascaded hubs using

each a 100 meter cable, then the cascading cable between the hubs must non exeed 5 meters (16

feet).

This limitation does not apply to switches, because they break up the path into separated collision

domains.

2.3. POWERING THE DEVICE

Plug the power cord coming from the power adaptor to the hub and then plug the power

adaptor into the power outlet.

Check that the power led on the front panel is on. After few seconds the device is ready to

work.

Note: In order to avoid damages to the device and consequent warranty void do not use other power

adaptors than the supplied one.

Straight RJ45-RJ45 cables

HUB/Switch port

Input Receive Data +

Input Receive Data -

Output Transmit Data +

Output Transmit Data -

Network station

or hub/switch uplink port

Output Transmit Data +

Output Transmit Data -

Input Receive Data +

Input Receive Data -

Installation