Epson 1280 - Stylus Photo Color Inkjet Printer 시작하기 매뉴얼 - 페이지 18

{카테고리_이름} Epson 1280 - Stylus Photo Color Inkjet Printer에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 1280 - Stylus Photo Color Inkjet Printer 32 페이지. Product support bulletin(s)
Epson 1280 - Stylus Photo Color Inkjet Printer에 대해서도 마찬가지입니다: 카트리지 교체 (2 페이지), 제품 지원 게시판 (6 페이지), 제품 지원 게시판 (1 페이지), 보충 설명서 (1 페이지), 사용자 설명서 (27 페이지), 호환성 매뉴얼 (1 페이지), 보충 설명서 (2 페이지), 여기에서 시작 (2 페이지), 브로셔 및 사양 (2 페이지), 제품 정보 (13 페이지), 여기에서 시작하기 매뉴얼 (6 페이지), 사양 (2 페이지), 사용자 설명서 (12 페이지), 제품 지원 게시판 (3 페이지), 제품 지원 게시판 (2 페이지), 제품 지원 게시판 (4 페이지), 제품 지원 게시판 (7 페이지), 설치 지침 매뉴얼 (8 페이지)

Sawgrass Technologies, Inc.

SubliJet IQ

Getting Started Guide for the EPSON Stylus Photo 1280

Tips for Using the

QuickConnect System

Check the 3M Dual Lock Tape connections periodically

Ensure the support arm is securely attached and not drooping, and that the lid props are

firmly attached. If the support arm droops too low, the tubing could scrape the bottom of

the printer.

Check the clearance periodically

Ensure there is clearance between the tubing going between the color cartridge and the

black cartridge and the printer's plastic overhang. Make sure the tubing isn't scraping the

overhang, or the tubing will become worn. If there is not a lot of clearance, pull the

overhang upward and hold if for 30 seconds to 'stretch' it.

Check the ink level in your ink bags periodically

As the bags empty, they flatten in appearance. Before beginning a large print job, check

the ink bags to ensure enough ink is available to finish the job.

Ink indicator shows as low, even though ink bags are full

The printer keeps track of how much ink has been used, and tries to write that level to the

chip. Because the chips are write protected, it is not successful at changing the ink level

value on the chips, however, the software based "Epson Status Monitor" reports the level

in the printer's memory to the computer. In order to clear the printer's memory and reset

it to the 100 percent full level on the chips, either unplug the printer for 1 second, or turn

it off via the front power button and leave it off for 15 or more seconds.

How to remove the QuickConnect system from the printer

Clamp off the tubes before removing. The cartridges may drip slightly when removed

from the printer because they are filled with more ink than the sponge can retain. Keep

the cartridges above the level of the ink bags until you are able to plug the exit holes with

3M electrical tape. Please note the exit port area must be perfectly dry or the tape won't

stick.