Epson 1430 CFS 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Epson 1430 CFS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 1430 CFS 10 페이지.

Step 6:

Install the CFS Assembly into the printer carriage routing the

tubes under the cross member as depicted in Fig. 6.

Step 7:

Fig. 7-1 gives a better angle on the routing of the tubes after

the installation of the CFS Cartridge Assembly.

The 2 Beige Clips are used to align the tubes and will be

installed in such a way as to keep the tubes in line from the

Bridge Bracket to the right edge of the printer.

As shown in Fig. 7-2, the first Beige Clip is installed on the left

side of the cross member in the top of the printer. Fig. 7-3

shows the location and orientation of the second Beige Clip on

the right side top of the printer. This will create a straight line

for the tubing from the Bridge Bracket on the left to the Beige

Clip on the right.

Before closing the Beige Clips on the tubing, slide the printer

carriage to the far right and adjust the tubing to ensure that

the tubing is not pulled tight at the Bridge Bracket, but also

does not hang loose. You will need to slide the printer carriage

from right to left to ensure that the carriage is able to move

with no restriction or resistance from the tubing. If the tubing

becomes tangled or twisted at any point during the carriage's

travel, the tension will need to be adjusted.

S a v e

M o n e y

MIS Associates Inc

http://www.inksupply.com

a n d

I m p r o v e

2901 Auburn Rd.

Auburn Hills, MI 48326

Fax: 248-289-6013

Fig. 6

Fig. 7-1

Fig. 7-2

Fig. 7-3

Y o u r

P r i n t i n g

800-445-8296